![]() ![]() Please ensure that either the RCD on the steam showers power cable or an RCD at the consumer box is utilised. Typically, this will be wired back to the consumer box and can be located on a separate breaker switch. Electrical Supply: The 3.0KW steam generators require a 16Amp dedicated power supply to the steam shower.Ball lever valves can be installed to allow quick shut-off of the water to the shower. The water supply pipes should be recessed and not protrude more than ½ inch from the wall. The steam shower will arrive with hot and cold braided hoses on the rear of the unit allowing the unit to be connected and pushed back into position. The input water supply should be balanced across the hot and cold supply, which can be achieved using a pressure equalising valve (PEV) or pressure reducing valve. The water supply pressure should be 2.5-3.0bar, which equates to a combined flow rate of 16-18 litres per minute across both supplies. Water Supply: The manufacturer's steam shower installation booklet will provide measurements to where the hot and cold feeds should be piped.The steam shower installation will require both a hot and cold water supply along with an electrical feed. Prior to purchasing you should have confirmed the cabin dimensions and know where in the bathroom you are placing the steam shower. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |